Sports Performance & Athlete Assessment
FLIR Oryx

Accentuated Eccentric Loading Increases Maximal Countermovement Jump Height Without Changes in Overall Lower Limb Kinetics and Energetics

European Journal of Sport Science
•
2026
•
Original research
Theia3D version:
v2022.1.0.2309
More Articles

Study at a glance

In 15 recreationally active men performing maximal countermovement jumps, Theia3D-based motion capture combined with force plates and surface electromyography found that accentuated eccentric loading with handheld dumbbells increased jump height and overall center-of-mass work, but without an accompanying increase in total lower-limb joint work, pointing researchers toward whole-body coordination, rather than greater lower-limb output, as the likely explanation.

Summary

Disclaimer: The following summary details independent academic research. Theia3D is intended for research, sports performance and educational use only. It is not cleared as a medical device and is not intended to be used for the diagnosis, treatment, mitigation or prevention of any disease, injury or medical condition.

Editor's note: Theia3D version 2022.1.0.2309, as stated in the paper. Here, Theia3D served as the full-body kinematic-capture tool underlying the study's joint kinetic and energetic analysis, rather than as a system being validated against marker-based motion capture within this particular study; the authors instead cite prior published validation work to support their use of Theia3D for lower-limb analysis specifically (see Study Limitations and Future Directions below for an important caveat the authors themselves raise about torso and upper-limb estimates).

Study Overview

Design

A within-subject, counterbalanced laboratory study comparing lower-limb joint kinetics, center-of-mass mechanics, and muscle activity between maximal countermovement jumps performed with and without accentuated eccentric loading using handheld dumbbells.

Participants

Fifteen healthy, recreationally active young adult men (mean age 22.3 years) with solid jumping ability, screened to ensure a minimum jump performance standard, with no current or previous major lower-limb trauma or movement-limiting condition reported.

Data Collection

Participants attended a familiarization session followed by a data-collection session 48 hours later. After a standardized warm-up, participants performed maximal countermovement jumps in a randomized order with and without AEL, holding two handheld dumbbells totaling 20% of body mass and releasing them near the bottom of the jump before jumping maximally; arm swing was restricted to isolate the loading effect. Full-body kinematics were recorded at 50 Hz using eight synchronized FLIR Oryx cameras processed through Theia3D, alongside ground reaction forces from dual force plates and surface electromyography from eight lower-limb muscles on the right leg.

Analysis

Theia3D-derived kinematics were combined with force plate data to calculate joint kinetics and energetics using inverse dynamics, examining center-of-mass velocity, power, and work, along with hip, knee, and ankle joint moments, powers, and work during the push-off phase. Paired statistical tests compared mechanical and electromyography outcomes between the AEL and non-AEL conditions, with correction for multiple comparisons.

Key Findings

  • AEL significantly increased effective jump height by an average of 2.1 centimeters (3.98%), along with greater peak and mean center-of-mass velocity and power during push-off, compared to jumps performed without added load.
  • Despite the higher jump, total lower-limb joint work summed across the hip, knee, and ankle during push-off did not differ significantly between the AEL and non-AEL conditions.
  • Right ankle joint power and work during push-off were significantly lower in the AEL condition than without added load, indicating the ankle contributed less to push-off despite the improved jump height.
  • Surface electromyography showed no consistent, load-related increase in activity across the eight lower-limb muscles measured, providing no support for increased muscular effort at the lower limb as the source of the AEL benefit.
  • The authors conclude that these findings do not support the common explanation that AEL enhances jump performance by increasing lower-limb work output, and instead propose that the additional center-of-mass work observed with AEL likely originated from body segments, such as the trunk and upper body, not captured in their lower-limb joint analysis, pointing to altered whole-body coordination as the more likely contributing mechanism.
  • Eleven of 15 participants showed a clear positive jumping benefit from AEL, while four did not, and the researchers found no obvious pattern in squat depth or baseline jump height that distinguished these two groups.

What This Means for Movement Science Researchers and Strength and Power Training Teams

For researchers and teams studying jump training and power development, this study offers a specific, evidence-based challenge to a commonly assumed mechanism: accentuated eccentric loading improved jump height in this sample, but the performance benefit was not explained by greater work output at the lower-limb joints, and in the case of the ankle, joint-level output actually decreased despite the improved outcome. This points researchers toward investigating trunk and upper-body coordination, rather than assuming increased lower-limb muscular effort, as the more promising explanation for why AEL works when it does, a distinction relevant to how training programs and performance-monitoring approaches are designed and interpreted going forward. The combined markerless motion capture, force plate, and electromyography approach used here also demonstrates a practically useful template for teams wanting to move beyond simple outcome measures like jump height to understand the underlying mechanics driving a training effect.

The Role of Theia3D in Movement Analysis

Theia3D served as the full-body kinematic-capture tool in this study, enabling joint-level kinetic and energetic analysis of the hip, knee, and ankle during a fast, explosive jumping movement without the marker-placement burden that could complicate capturing both lower-limb and upper-body motion simultaneously during repeated maximal-effort trials. The authors cite prior published validation research supporting Theia3D's reliability and agreement with marker-based systems specifically for lower-limb kinematics and kinetics, which they used as the basis for their analysis approach, while explicitly noting that this same level of validation support does not yet extend to torso and upper-limb estimates from the Theia3D model (see Study Limitations and Future Directions below).

Study Limitations and Future Directions

The authors identify a notable, specific caveat relevant to their own central interpretation: the torso and upper-limb segments of the Theia3D model used in this study have not been sufficiently validated with experimental data, so while the researchers hypothesize that the trunk and upper body likely contributed the additional center-of-mass work observed with AEL, they note this remains a hypothesis generated by their data rather than a finding they could directly confirm with their current model, and they call for future studies specifically designed to measure trunk and arm contributions to test this mechanism directly. Other limitations include a camera frame rate of 50 Hz, which required up-sampling the data to more precisely identify the turning point of the jump, introducing some uncertainty into the timing of dumbbell release; a sample limited to recreationally active, sub-elite male adults, which may not generalize to elite athletes or to female athletes, given known differences in anatomy, neuromuscular function, and movement strategy between sexes that were not tested directly in this study; use of a single fixed AEL load (20% of body mass) rather than a range of loads; and the absence of trunk muscle activity data, which limited the researchers' ability to directly confirm their proposed trunk-contribution mechanism. The authors identify incorporating trunk and upper-limb kinematic and muscle-activity measurements, testing a broader range of AEL loads, and extending this approach to female and more highly trained athletic populations as important next steps.

Citation: Su, E. Y.-S., Carroll, T. J., Farris, D. J., & Lichtwark, G. (2026). Accentuated eccentric loading increases maximal countermovement jump height without changes in overall lower limb kinetics and energetics. European Journal of Sport Science, 26, e70228. https://doi.org/10.1002/ejsc.70228

Link: Read the full study

Does Accentuated Eccentric Loading Actually Increase Lower-Limb Work During a Jump?

This study of 15 recreationally active men uses Theia3D markerless motion capture alongside force plates and electromyography to show that accentuated eccentric loading increases jump height without a corresponding increase in total lower-limb joint work, pointing toward trunk and whole-body coordination as the more likely explanation. If your work involves sports performance or power-training research, talk to our team about applying Theia3D to your own studies.

Recent Posts