Study at a glance
Summary
Disclaimer: The following summary details independent academic research. Theia3D is intended for research, sports performance and educational use only. It is not cleared as a medical device and is not intended to be used for the diagnosis, treatment, mitigation or prevention of any disease, injury or medical condition.
Editor's note: Theia3D version 2023.1.0.3161, as stated in the paper. Here, Theia3D served as the motion-capture tool for a research question about change-of-direction technique, rather than as a system being validated against marker-based motion capture within this particular study; the authors cite prior published Theia3D validation research, including their own earlier work on change-of-direction kinematics specifically, to support their use of the system.
Study Overview
Design
A cross-sectional biomechanical study examining the kinematic characteristics associated with change-of-direction performance and knee abduction angle, used as a kinematic marker of ACL-related loading risk, during a pre-planned 90-degree change-of-direction task in basketball players.
Participants
Thirty-four healthy male basketball players (age 19.7 years; mass 67.3 kg; height 1.73 m), with more than three years of basketball experience, well-trained in change-of-direction maneuvers in both directions, and free of lower-limb musculoskeletal trauma in the six months prior to testing or a history of serious knee trauma requiring surgery.
Data Collection
Participants ran 10 meters at maximal effort, made foot contact within a defined cutting area, performed a pre-planned 90-degree change of direction opposite their stance leg, and then ran a further 10 meters, completing five trials in their preferred cutting direction. Movement was captured using ten Sony RX0-II video cameras (120 Hz, full HD resolution) processed through Theia3D.
Analysis
Hip, knee, and trunk joint angles were extracted during the weight-acceptance phase of the cut (from initial contact to peak knee flexion), along with completion time, contact time, and running velocity measures derived from whole-body center-of-mass position. Associations between knee abduction angle, completion time, and the other kinematic and performance variables were tested using correlation analysis. Participants were also classified into a "Fast and Low-Risk" group and a "Slow and High-Risk" group based on a combined score of completion time and knee abduction angle, with between-group comparisons used to characterize the movement strategies distinguishing the two groups.
Key Findings
- Smaller knee abduction angles were significantly associated with greater hip abduction, greater hip internal rotation magnitude, and greater trunk forward flexion, lateral flexion, and rotation toward the cutting direction, while greater knee abduction was associated with greater knee and hip flexion.
- Shorter completion times were strongly associated with higher approach velocity, higher exit velocity, higher maximum running velocity, and a lower deceleration rate (less velocity lost during the cut).
- Compared with the Slow and High-Risk group, the Fast and Low-Risk group showed significantly smaller knee abduction angles, shorter completion times, higher approach and exit velocities, and a lower deceleration rate, with very large to large effect sizes for these differences.
- The Fast and Low-Risk group also showed significantly reduced trunk extension and greater trunk rotation toward the cutting direction compared to the Slow and High-Risk group, with no significant difference between groups in maximum running velocity, indicating that the Fast and Low-Risk group's performance advantage stemmed specifically from limiting velocity loss during the cut rather than from superior straight-line sprinting speed.
- The authors conclude that maintaining velocity through the cutting phase and orienting the trunk toward the cutting direction, rather than leaning toward the stance leg, is associated with both faster completion times and smaller knee abduction angles, outlining a specific movement strategy that might help athletes avoid the traditional performance-versus-loading-risk tradeoff in change-of-direction maneuvers.
What This Means for Movement Science Researchers and Basketball and Multidirectional Sports Performance Teams
For researchers and performance staff working with basketball players and other multidirectional sport athletes, this study offers a specific, practically actionable finding: rather than treating change-of-direction speed and lower knee loading risk as inherently opposed goals, coaching that emphasizes limiting velocity loss during the cut and keeping the trunk rotated toward the cutting direction, instead of leaning toward the stance leg, may support both outcomes at once. This gives technique coaches a concrete, specific target, trunk orientation and velocity maintenance through the cut, rather than only general cues like "cut faster" or "bend your knees more," potentially helping athletes develop change-of-direction technique that supports performance without requiring a tradeoff in loading-related risk.
The Role of Theia3D in Movement Analysis
Theia3D served as the markerless motion-capture tool in this study, enabling detailed kinematic measurement of a fast, explosive change-of-direction maneuver under conditions resembling a genuine sports environment, free of the physical constraints that reflective markers and laboratory setups can impose on athletes' natural movement. The authors note that this ecological validity made the findings more practical and useful for coaches and athletes, and they cite prior published Theia3D validation research, including their own earlier work specifically validating Theia3D for change-of-direction kinematics, to support confidence in the measurements used here.
Study Limitations and Future Directions
The authors note that this study collected no kinetic measurements, meaning they could not directly analyze knee joint moments or other kinetic loads, and instead used knee abduction angle, which has been reported to predict knee abduction moment, as a kinematic proxy for ACL-related loading risk; they identify incorporating direct kinetic measurement as an important next step. The change-of-direction task used was pre-planned, with the cutting direction known in advance, and the authors caution that differences in kinematics and kinetics have been reported between pre-planned and unanticipated cutting tasks, so these findings should be applied cautiously to the reactive, perception-driven cutting situations typical of actual game-based agility. The study did not directly quantify fatigue or learning effects across repeated trials, which could have subtly influenced the kinematic and performance measures observed despite rest intervals between attempts. The authors also note a specific methodological caveat regarding their trunk kinematic calculations: because the rotation sequence used to calculate trunk angles involves inherent mathematical coupling between rotation axes, the trunk findings should be interpreted as indicators of overall trunk movement patterns and postural strategy rather than as fully independent, isolated single-axis measurements. Finally, the sample consisted exclusively of young men, so these findings may not generalize to female athletes or other populations who may show different kinematic patterns during change-of-direction maneuvers. The authors identify incorporating kinetic measurements, testing unplanned and reactive cutting tasks, and extending this research to a broader range of athletic populations as important next steps.
Citation: Nishikawa, N., Ueno, T., Watanabe, S., & Yamamoto, K. (2026). Kinematic assessment of ACL injury risk and performance during 90° change-of-direction maneuvers. Asian Journal of Kinesiology, 28(1), 30-40. https://doi.org/10.15758/ajk.2026.28.1.30
Link: Read the full study
Can Athletes Cut Faster Without Increasing ACL Loading Risk?
This study of 34 male basketball players uses Theia3D markerless motion capture to show that maintaining velocity through a 90-degree cut and rotating the trunk toward the cutting direction is associated with both faster completion times and smaller knee abduction angles, pointing to a movement strategy that may help avoid the traditional tradeoff between change-of-direction performance and ACL-related loading risk. If your work involves basketball or multidirectional sports performance and technique research, talk to our team about applying Theia3D to your own studies.