Sports Performance & Athlete Assessment
Qualisys Miqus

Assessment of Asymmetrical Lower Limb Range of Motion in Six-Step, a Basic Footwork in Breakdance (Breaking)

Journal of Dance Medicine & Science
•
2026
•
Original research
Theia3D version:
v2021.2.0.1675
More Articles

Study at a glance

In 10 expert breakdancers performing the Six-Step, the most fundamental footwork pattern in breaking, Theia3D-based motion capture found that the "axis" leg required significantly greater hip adduction and knee flexion range of motion than the opposite leg, with knee flexion on the axis side closely linked to hip adduction and internal rotation on that same side.

Summary

Disclaimer: The following summary details independent academic research. Theia3D is intended for research, sports performance and educational use only. It is not cleared as a medical device and is not intended to be used for the diagnosis, treatment, mitigation or prevention of any disease, injury or medical condition.

Editor's note: Theia3D version 2021.2.0.1675, as stated in the paper. Here, Theia3D served as the motion-capture tool for a research question about movement asymmetry in breaking, rather than as a system being validated against marker-based motion capture within this particular study; the authors instead cite prior published Theia3D validation research to support their use of the system.

Study Overview

Design

A cross-sectional biomechanical study examining side-to-side differences in maximum hip and knee range of motion between the axis-side and non-axis-side lower limb during the Six-Step footwork pattern in experienced breakdancers, using markerless motion capture.

Participants

Ten breakdancers (nine men, one woman; mean age 29.0 years), all with substantial breaking experience and proficiency, including several who had placed first in regional competitions, currently competed, served as judges, or worked as instructors.

Data Collection

Each participant performed four continuous cycles of the Six-Step sequence in their usual training attire and footwear, at their own natural performance speed. Movement was captured using six Qualisys Miqus high-speed cameras (85 Hz, 1080p resolution) processed through Theia3D, which tracked joint angles across the full six-phase Six-Step cycle.

Analysis

Maximum hip and knee range of motion on both the axis and non-axis sides were extracted across the sagittal, frontal, and transverse planes (extension/flexion, adduction/abduction, and internal/external rotation) and compared between limbs. Correlations between hip and knee range of motion on each side, and between interlimb range-of-motion differences and participant characteristics such as age, height, practice duration, and grip strength, were also examined, with within-subject repeatability between movement cycles assessed to confirm the measures included were sufficiently reliable for analysis.

Key Findings

  • The axis-side leg showed significantly greater hip adduction range of motion than the non-axis leg (20.3° vs. 9.2°, more than double), and significantly greater knee flexion range of motion (152.8° vs. 142.0°).
  • Axis-side knee flexion averaged nearly 153 degrees, approaching the physiological maximum range of motion observed in healthy individuals, reflecting the demanding, deep knee-flexion posture required by this specific technique.
  • On the axis side specifically, greater knee flexion range of motion was significantly correlated with greater hip adduction range of motion and greater hip internal rotation range of motion on that same limb, indicating these movements function together as a coordinated demand during the Six-Step, a pattern not observed on the non-axis side.
  • No significant correlation was found between the degree of interlimb range-of-motion asymmetry and any individual participant characteristic measured, including age, height, weight, body mass index, practice duration, or grip strength difference between limbs.
  • The authors frame this asymmetry as an inherent, movement-specific characteristic of the Six-Step itself, consistently present regardless of the specific dancers studied, rather than something explained by individual differences among the participants.

What This Means for Movement Science Researchers and Dance Performance and Conditioning Teams

For researchers and conditioning staff working with breakdancers, this study offers a specific, concrete biomechanical foundation that had previously been missing: clear, quantified evidence of exactly how much greater hip and knee demand the axis-side leg experiences during the single most foundational footwork pattern in the discipline. Given that axis-side dominance is typically self-selected and consistently repeated across a dancer's training and competitive career, this asymmetry offers researchers and conditioning teams a specific, measurable movement pattern to incorporate into future work on mobility assessment, side-specific strength and conditioning approaches, and technique development in breaking. The markerless motion-capture approach used here also illustrates a practical advantage for dance-specific research: capturing detailed joint-angle data across a fast, acrobatic, floor-based sequence without the marker setup and placement challenges that movements like the Six-Step, involving frequent hand-to-floor contact and rapid body reorientation, could otherwise pose.

The Role of Theia3D in Movement Analysis

Theia3D served as the markerless motion-capture tool in this study, enabling detailed, frame-by-frame measurement of hip and knee joint angles throughout a fast, acrobatic, floor-based breakdance sequence without the need for reflective markers that could interfere with the dancers' natural performance or be disrupted by the movement's frequent ground contact. It was not itself compared against marker-based motion capture within this particular study; the authors instead relied on prior published Theia3D validation research, alongside their own within-subject repeatability check across movement cycles, to support confidence in the measurements used.

Study Limitations and Future Directions

The authors note that their sample consisted entirely of experienced, expert breakdancers, so these findings may not generalize to novice dancers or more casual, community-level practice. Participants performed the Six-Step at their own natural performance speed without standardizing movement tempo across dancers, which, while prioritizing a realistic representation of typical performance, could have influenced the kinematic measures observed. The study was also limited by a small sample size, and the authors' own power analysis indicates it was likely underpowered to detect weak-to-moderate correlations, meaning the absence of significant associations between interlimb differences and participant characteristics should not be interpreted as firm evidence that no such relationship exists. All participants were of a single ethnic background, and the study did not collect broader sociodemographic information, which the authors note as a limitation for understanding how these factors might influence the findings. The authors identify evaluating the longer-term biomechanical significance of repeated exposure to Six-Step asymmetry, clarifying whether this asymmetry is advantageous, detrimental, or neutral for both performance quality and lower-limb loading, and broadening future research to a more demographically diverse and gender-balanced group of breakdancers as important next steps.

Citation: Tsuda, T., Kutsuna, T., Kiyomatsu, H., Kinoshita, T., & Takao, M. (2026). Assessment of asymmetrical lower limb range of motion in Six-Step, a basic footwork in breakdance (breaking). Journal of Dance Medicine & Science. Advance online publication. https://doi.org/10.1177/1089313X261454491

Link: Read the full study

How Much Does the Six-Step Demand Asymmetrical Hip and Knee Motion in Breakdancing?

This study of 10 experienced breakdancers uses Theia3D markerless motion capture to show that the Six-Step, breaking's most foundational footwork pattern, requires significantly greater hip adduction and knee flexion range of motion on the axis-side leg than the opposite leg. If your work involves dance science or sports performance research, talk to our team about applying Theia3D to your own studies.

Recent Posts